Equipment

This two-user nitrogen glovebox is equipped to hold instrumentation for automated dispensing of reagents. It includes a freezer and regenerable solvent removal system

Designed for rapid analysis of complex mixtures, the system can be used as either a stand-alone SFC-MS or with an initial achiral UPLC separations with the SFC as a second ana

Available for dispensing as little as 0.1 μl with as little as 6 μl dead volume, this liquid dispenser is great for adding reagents to 24, 48, 96, and 384 well plates. 

Offering automated control and recording of  temperature, pressure, stirring rates, in situ IR, and almost any external sensor, the EasyMax is great for data-rich experiments

Designed for high pressure reaction screening. Equipped with six 45 ml reactors made of alloy C276 with individual stirring, heating, and pressure transducers.

For analysis of simple to complex reaction mixtures. The two columns enable the GC to analyze both organic products and permanent gases. Other columns available as needed.

For isolation-scale reverse phase separations. Fitted with both analytical and prep-scale columns to assist transfer of analytical methods. Fitted with a diode array detector.

From V&P Scientific, this reactor allows for screening up to 48 reactions in GC vials at pressures up to 300 PSIG. Reactions have a shared headspace.

These NMR tubes are made from PEEK polymer and capable of withstanding pressures up to 500 PSI. Used for work in with spectrometers in the CBIC.

Capable of holding any SLAS-footprint deep-well plate. Shaking is adequate to mix most reactions, and temperature is regulated between -10 and 110 °C.

We have a variety of Eppendorf micropipettes. Manual and electronic single- and multi-channel pipettes allow for rapid dispensing of simple plate designs.

This single-user glovebox is ideal for setting up and taking down air-sensitive reactions.

This instrument is designed for the automated weighing of solids, from fine powders to wet-sand textures. The robot can queue multiple dispensing jobs (3 blocks and 7 solids).

This centrifugal evaporator is designed for parallel evaporation of vials, plates, or column fractions. The incorporated condensing trap eliminates the need for cold baths.

A 3-position stirring and heating solution for microplates and 96-vial arrays. Can heat up to 180 °C and is designed to ensure even stirring across the plate.